Oil Pump Bushing Replacement; Reaction Shaft Support Bushing Removal; Pump Gear Removal; Support Hub Thrust Washer - Jeep 200 Cherokee Service Manual

21 - 178 AUTOMATIC TRANSMISSION—30RH
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 174 Pump Gear Removal
1 – REACTION SHAFT SUPPORT
2 – INNER GEAR
3 – OUTER GEAR
Fig. 175 Support Hub Thrust Washer
1 – BUSHING
2 – REACTION SHAFT SUPPORT
3 – THRUST WASHER
4 – HUB

OIL PUMP BUSHING REPLACEMENT

(1) Remove pump bushing with Tool Handle
C-4171 and Bushing Remover SP-3551 from Tool Set
C-3887-J (Fig. 176).
(2) Install new pump bushing with Tool Handle
C-4171 and Bushing Installer SP-5117 (Fig. 176).
Bushing should be flush with pump housing bore.
(3) Stake new pump bushing in two places with
blunt punch (Fig. 177). Remove burrs from stake
points with knife blade afterward.

REACTION SHAFT SUPPORT BUSHING REMOVAL

(1) Assemble Bushing Remover Tools SP-1191,
3633 and 5324 (Fig. 178). Do not clamp any part
of reaction shaft or support in vise.
(2) Hold Cup Tool SP-3633 firmly against reaction
shaft and thread remover SP-5324 into bushing as
Fig. 176 Removing Oil Pump Bushing
1 – SPECIAL TOOL C-4171
2 – SPECIAL TOOL SP-3551
3 – BUSHING
4 – SPECIAL TOOL SP-5117
5 – BUSHING
6 – SPECIAL TOOL C-4171
7 – PUMP HOUSING
Fig. 177 Staking Oil Pump Bushing
1 – NARROW BLADE
2 – BLUNT PUNCH
3 – TWO STAKES
far as possible by hand. Then thread remover tool 3-4
additional turns into bushing with a wrench.
(3) Turn remover tool hex nut down against
remover cup to pull bushing from shaft. Clean all
chips from shaft after bushing removal.
XJ