Installing Light Assembly; Connecting Transport Lighting Module; Installing Remote Control - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)

Installing Light Assembly

1. Locate right side light assembly (A).
NOTE:
When the mower is in field position, the right light
assembly is located on the left, rear side of the mower.
When the machine is being towed, it will be on the
right side.
2. Loosen bolt (C). Rotate the light assembly (A) up to
position shown at right.
3. Install bolt (B).

Connecting Transport Lighting Module

1. Connect harness (A) to transport lighting module (B).

Installing Remote Control

1. Retrieve remote control (A) with wiring harness.
2. Place remote control (A) on hitch temporarily.
214713
B
Figure 4.70: Left, Rear End of Mower
B
A
Figure 4.71: Transport Lighting Module
Figure 4.72: Remote Control on Top of Hitch
85
C
A
Revision A
A