MacDon R116 Unloading And Assembly Instructions page 40

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
6. Install latch assembly (A) onto the carrier frame as
shown, and secure with the M20 bolts, washers, and
nuts (B) retained in Step
tighten bolts; adjustment of the latch assembly may be
necessary.
7. Loosen fitting (A) on the cylinder lockout valve.
8. Remove elbow fitting (B) from the cylinder.
9. Install tee fitting (A) in place of the elbow fitting.
10. Install cylinder lockout valve (B) on tee fitting (A)
as shown.
11. Attach hydraulic hose (C) from the latch assembly to
tee fitting (A) as shown.
214713
5, page 31. Do NOT fully
A
Figure 3.55: Latch Assembly
B
Figure 3.56: Latch Plumbing
C
A
Figure 3.57: Latch Plumbing
32
B
A
B
Revision A