MacDon R116 Unloading And Assembly Instructions page 50

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
6. Align the hole in cam arm (A) with the hole in cylinder
clevis (B).
7. Ensure the end of cam arm (A) is parallel with the clevis
end (B) of the cylinder. If adjustment is required, use a
bar to turn the clevis until the clevis is parallel with
cam arm (A).
NOTE:
The clevis end of the cylinder will be attached to the
Road Friendly Transport
is primed. Refer to 5.5 Priming the Hitch Swing
Cylinder, page 102.
214713
™
casting when the system
Figure 3.83: Alignment Control (Rear
Right View)
Figure 3.84: Cam Arm Alignment
42
A
B
A
B
Revision A