MacDon R116 Unloading And Assembly Instructions page 22

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
9. Move hitch pivot (A) into attachment location (B) on
carrier, and line up hitch pin with hole in carrier.
10. Slowly lower hitch (A) while maintaining pin alignment
until hitch pin (B) is fully inserted. Use a large soft
hammer if necessary to seat hitch pin.
11. Line up holes in hitch pin (A) with holes in the carrier
frame. Install six M20 x 65 bolts (B) with hardened
washers under the bolt head and lock nuts (C).
214713
Figure 3.14: Hitch to Carrier
Figure 3.15: Hitch Pin
C
Figure 3.16: Hitch Pin
14
A
B
A
A
B
B
Revision A