ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
16. Remove cone shield (A).
17. Retrieve the primary driveline (D) from the shipping
location.
18. Remove nut (C), washer (B), and pin (A) from the disc
mower end of primary driveline (D).
19. Slide driveline (A) onto gearbox input shaft (B). Align
the pinhole in the yoke with the groove on the
input shaft.
214713
A
Figure 3.35: Cone Shield
Figure 3.36: Primary Driveline
A
Figure 3.37: Primary Driveline
22
D
A
B
C
B
Revision A