Setting Up Forming Shields; Setting Up Forming Shields For Finger Conditioner - MacDon R116 Unloading And Assembly Instructions

5.6 Setting up Forming Shields

Each type of conditioner uses a different configuration for the swath forming shield. Refer to the applicable
instruction for the conditioner supplied with the machine.
If a finger conditioner is installed, continue to
If a roll conditioner is installed, continue to
If no conditioner is installed, continue to

5.6.1 Setting up Forming Shields for Finger Conditioner

NOTE:
Transport not shown in illustrations for clarity.
1. Before setting up the forming shields, convert the
header to field mode. Refer to
Transport to Field Mode (With Road Friendly
™
Transport ), page 166.
2. Remove shipping wires (A) securing forming shield
covers (B) to pallet.
3. Support shield (C), remove two bolts at locations (A)
and (B), and remove the shield.
214713
SETTING UP THE TRACTOR
5.6.1 Setting up Forming Shields for Finger Conditioner, page
5.6.2 Setting up Forming Shields for Roll Conditioner, page
5.8 Discharge Shield (No Conditioner), page
8.6.2 Converting from
104
112.
A
Figure 5.24: Forming Shields Strapped to Pallet
A
Figure 5.25: Outboard Top Cover
104.
109.
B
A A
B
C
Revision A