Closing Driveshields - MacDon R116 Unloading And Assembly Instructions

6.3 Closing Driveshields

CAUTION
Do NOT operate the machine without the driveshields in place and secured.
NOTE:
Images shown in this procedure are for left driveshield—right driveshield is similar.
1. Position driveshield onto pins at base of driveshield
(if necessary).
2. Push driveshield (A) to engage latch (B).
3. Check that driveshield is properly secured.
4. Replace tool (B) and lynch pin (A) on pin (C).
214713
LUBRICATING THE DISC MOWER
126
Figure 6.10: Driveshield and Latch
A
B
C
Figure 6.11: Left Driveshield
A
B
Revision A