MacDon R116 Unloading And Assembly Instructions page 78

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
7. Using a floor jack or equivalent, raise two-point hitch
adapter (A) into position under the gearbox.
8. Maneuver adapter (A) so that pin (B) can be installed to
secure adapter to hitch.
9. Secure pin with bolt (C) and nut (D).
10. Remove floor jack, and remove remaining strapping
and pallet from hitch adapter.
11. Retrieve stand (A).
12. Position stand (A) under gearbox as shown, and install
hitch pin (B) to secure the stand.
13. Install hairpins (C) to secure hitch pin (B).
14. Lower hitch and stand to the ground.
15. Install springs (A) into hooks (B). Repeat on
opposite side.
214713
D
C
B
Figure 4.35: Two-Point Hitch Adapter
A
Figure 4.36: Stand
Figure 4.37: Springs
70
A
C
B
A
B
Revision A