Attaching Hitch To Carrier - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)

3.2 Attaching Hitch to Carrier

1. Remove M20 bolts (A), washers, and nuts from carrier
at the hitch attachment location. Retain bolts, washers,
and nuts.
2. Cut banding (A) securing wood supports, then
remove supports (B).
3. Remove the two bolts securing wood support to hitch
pin (C). Discard bolts.
4. Place sling (A) around the hitch frame. Adjust sling
position until hitch is balanced when lifting.
•
R113: Approximately 2.7 m (106 in.) from the edge
of the tractor end of the hitch (B)
•
R116: Approximately 3.5 m (138 in.) from the edge
of the tractor end of the hitch (B)
5. Raise the hitch approximately 610 mm (24 in.) off
the ground.
214713
Figure 3.8: Carrier
C
B
Figure 3.9: Hitch Packing
A
Figure 3.10: Lifting Hitch
12
A
A
B
Revision A