Installing New Right Drum Assembly - MacDon R116 Installation Instructions Manual

3.5 Installing New Right Drum Assembly

To install the new counterclockwise drum assembly (MD #257086) provided in the kit, follow these steps:
WARNING
Wear heavy gloves when working around or handling knives. Blades are sharp and can cause serious injury.
NOTE:
Unless otherwise specified, all parts are provided in the kit.
1. Ensure spacer (A) is on spindle.
2. Position new counterclockwise drum assembly (B)
(MD #257086) onto the spindle as shown. The disc must be
positioned at a 90-degree angle relative to
neighboring discs.
3. Use an 18 mm deep socket to install four M12 bolts (A)
(MD #281697) and washers (MD #246952), securing drum
assembly (B) to the spindle.
4. Torque to 85 Nm (63 lbf·ft).
214913
INSTALLATION INSTRUCTIONS
Figure 3.9: Non-Driven Spindle
Figure 3.10: Counterclockwise Drum Assembly
Installed
14
A
B
A A A
A
Revision B