Setting Up Forming Shields For Roll Conditioner - MacDon R116 Unloading And Assembly Instructions

5.6.2 Setting up Forming Shields for Roll Conditioner

Use these instructions to set up the forming shields on a machine with a roll conditioner.
1. Remove and discard bolt (A) securing forming
shield (B) to frame.
2. Swivel shield (B) to the open position.
3. Rotate clamp (B) until you can remove bolt (C).
4. Swing adjuster bar (A) and align with a hole on carrier
plate (D).
5. Install bolt through adjuster bar (A) and carrier plate (D).
Install clamp (B) onto bolt. Tighten clamp until shield
does not move.
6. Repeat above steps for opposite shield.
214713
SETTING UP THE TRACTOR
Figure 5.38: Left Side Forming Shield
Figure 5.39: Adjuster Bar
109
B
D
C
A
Revision A
A
B