Installing Light Assembly; Connecting Transport Lighting Module - MacDon R113 Assembly Instruction Manual
Rotary disc pull-type
Hide thumbs
Also See for R113:
- Operator's manual (294 pages) ,
- Unloading and assembly instructions (166 pages) ,
- Assembly instruction manual (136 pages)
Table of Contents
Advertisement
ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT
Installing Light Assembly
Light assemblies provide position, hazard, turning direction, and braking information.
1. Locate right light assembly (A).
NOTE:
When the pull-type is in field position, the right light
assembly is located on the left, rear side of the pull-type.
When the machine is being towed, it will be on the
right side.
2. Loosen bolt (C). Rotate light assembly (A) up to position
shown at right.
3. Install bolt (B).
Connecting Transport Lighting Module
1. Connect harness (A) to transport lighting module (B).
215585
Figure 4.76: Left, Rear End of Pull-Type
Figure 4.77: Transport Lighting Module
93
Revision A
Advertisement
Table of Contents
