ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
10. Using a floor jack or equivalent under pallet (A), raise
drawbar hitch (B) into position under the gearbox.
11. Move drawbar hitch (B) so pin (C) can be installed.
12. Secure pin with bolt (D) and nut.
13. Remove floor jack, and if necessary, remove remaining
strapping and pallet (A) from hitch adapter.
14. Remove cone shield (A).
15. Retrieve the primary driveline (D) from the shipping
location.
16. Remove nut (C), washer (B) and pin (A) from the disc
mower end of the primary driveline (D).
214713
C
Figure 3.23: Drawbar Hitch
A
Figure 3.24: Cone Shield
Figure 3.25: Primary Driveline
18
D
B
A
D
B
C
Revision A
A