MacDon R116 Unloading And Assembly Instructions page 170

5. Operate the hitch swing control lever to rotate the disc
mower to the right until cam bearing nut is aligned with
the green section of the transport alignment
gauge decal.
6. Move transport switch to the upper position and ensure
that the light is NOT illuminated. The hitch swing circuit
is now deactivated and the transport circuit is active.
7. Operate hitch swing control lever to lower transport
wheels (A) and hold lever until disc mower is lifted off
the ground.
8. Continue to hold the hitch swing control lever so that the
disc mower (B) rotates to the left and under the hitch.
9. Release hitch swing control lever when disc mower (C)
stops rotating.
214713
TRANSPORTING THE DISC MOWER
162
Figure 8.17: Disc Mower Rotation
Figure 8.18: Transport Switch
A
Figure 8.19: Transport Assembly Rotation
B C
Revision A