ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
5. Install jack support stand (A) as shown. Secure with two
M12 X 1.75 X 40 bolts (B), M12 washers and M12
center lock nuts per side. Torque hardware to 68.5 Nm
(51 lbf ft)
6. Install jack (A) at front of hitch, and secure with pin (B).
7. Lower forklift until hitch is resting on hitch jack (A).
8. Remove shipping wire (A) that secures pin (B) in
casting. Do NOT remove other strapping.
9. Remove pin (B) from casting and remove bolt (C) and
nut from pin.
214713
Figure 4.23: Jack Stand Support
B
Figure 4.24: Jack Stand
Figure 4.25: Hitch Casting
66
B
A
A
B
A
Revision A
C