Predelivery Checklist - MacDon R116 Unloading And Assembly Instructions

Predelivery Checklist

Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are
required, refer to the appropriate page number in this manual. The completed Checklist should be retained by
either the Operator or the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Disc Mower Serial Number:
ü ü Item
Check for shipping damage or missing parts. Be sure
all shipping dunnage is removed.
Check for loose hardware. Tighten to required torque
if applicable.
Check that hydraulic hoses have adequate slack
before rotating header.
Check main drive belt tension.
Check header angle. Set center-link to middle of
adjustment range.
Check header float.
Check tire pressure.
Ensure wheel bolts are torqued to 160 Nm (120 lbf·ft).
Check side forming shields evenly set to
desired position.
Check rear baffle is about mid-position
(roll conditioner).
Check forward baffle lever is set to approximate mid-
position (finger conditioner).
Check rear baffle lever is set to approximate mid-
position (finger conditioner).
Check conditioner roll gap (roll conditioner).
Check conditioner roll tension (roll conditioner).
Check conditioner roll timing hardware is securely
tightened (roll conditioner).
Check that tall crop dividers are not installed for
road transport.
214713
Hitch Serial Number:
Reference
11.6 Torque Specifications, page 208
7.3 Checking Conditioner Drive Belt, page 129
7.4 Checking Cutting Angle, page 130
7.6 Checking Disc Mower Float, page 132
7.2 Checking Tire Pressure, page 128
7.1 Checking Wheel Bolts, page 127
5.6 Setting up Forming Shields, page 104
7.14 Adjusting Conditioner Baffle Position, page 144
7.14 Adjusting Conditioner Baffle Position, page 144
7.14 Adjusting Conditioner Baffle Position, page 144
7.11 Checking Roll Gap, page 140
7.13.1 Adjusting Roll Tension, page 143
7.12 Checking Roll Timing, page 142
4.9.2 Installing Tall Crop Divider (Optional), page 88
223
—
—
Revision A