MacDon R116 Unloading And Assembly Instructions page 88

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
2. Check the travel of the cam arm (A) by sliding it in and
out of the cam assembly (B).
NOTE:
If the cam arm does not slide easily, loosen valve
mounting bolts (C), and slide the valve (B) up to the top
of the mounting holes. Retighten valve mounting
bolts (C).
3. Align the hole in the cam arm (A) with the hole in the
cylinder clevis (B).
214713
Figure 4.58: Alignment Control (Rear
Right View)
Figure 4.59: Alignment Control (Rear
Right View)
80
B
A
C
A
B
Revision A