MacDon R116 Unloading And Assembly Instructions page 57

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
28. Route hose (A) through opening (E) at the rear of
the frame.
29. Feed shortest hose (A) through opening (B) in carrier
frame as shown with male end (C) at the hitch pivot.
30. Connect hose (A) (MD #247106) and hose (D)
(MD #224160 or MD #224162) at the hitch pivot.
31. Retrieve ORFS-6 x ORB-8 elbow from the
hardware bag.
32. Remove plug at base of lift cylinder and install elbow (A)
as shown.
33. Connect hose (B) to elbow and tighten.
34. Tighten remaining connections.
35. Secure hose to cylinder with cable tie (C).
214713
Figure 3.97: Lift Hose
Figure 3.98: Lift Cylinder
49
D
A
C
E
C
B
A
Revision A
B