MacDon R116 Unloading And Assembly Instructions page 42

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
Installing Transport Assembly
1. Remove two bolts (A), hardened washer, and nut
securing slow moving vehicle (SMV) sign (B) to the
carrier frame, and remove sign. Retain sign and
hardware for reinstallation.
2. Remove transport wheels (A) from the pallet.
3. Remove the five M20 hex head bolts (B), washers, and
nuts in transport assembly pin (C). Do NOT remove pin.
4. Using a forklift, pick up the pallet holding the transport
assembly (A) and align it with the rear of the
disc mower.
5. Position the assembly close behind the frame and align
pin (B) in transport assembly with hole (C) in the carrier.
Use a soft hammer or equivalent to fully insert pin (B).
214713
Figure 3.59: SMV Sign Attached to
Carrier Frame
B
C
Figure 3.60: Transport Packing
B
A
Figure 3.61: Road Friendly Transport
34
A
B
A
C
™ ™
Revision A