MacDon R116 Unloading And Assembly Instructions page 71

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
10. Install hitch pin (A) fully into hitch.
11. Pivot the gearbox (A) towards the right side of the disc
mower. This will increase the clearance to the driveline
clutch when installing hitch onto carrier frame.
12. Maneuver hitch pivot (A) into attachment location (B) on
carrier and line up pin with hole in carrier.
NOTE:
Align hitch pivot at a slight angle when installing to
prevent the driveline from contacting the header drive
gearbox.
214713
Figure 4.16: Pivot Pin
A
Figure 4.17: Driveline Shield
Figure 4.18: Hitch to Carrier
63
A
B
A
Revision A