MacDon R116 Unloading And Assembly Instructions page 102

4. Lower hitch with the jack so that pin (A) engages
drawbar hitch adapter (B).
5. Install clevis pin (C) and secure with lynch pin (D).
6. Position primary driveline (A) onto tractor power take-
off (PTO).
7. Pull back collar (B) on driveline (A), and push driveline
until it locks. Release collar.
8. Route safety chain (C) from disc mower through chain
support (D) on drawbar hitch adapter and around tractor
drawbar support. Lock hook on chain.
IMPORTANT:
If the tractor has a three-point hitch, lift the links as far
as possible to prevent damage to the hitch.
9. Raise jack (A), and remove pin (B).
214713
SETTING UP THE TRACTOR
Figure 5.5: Disc Mower Hitch
Figure 5.6: Primary Driveline
Figure 5.7: Hitch Jack
94
A
B
D
B A
C
D
B
A
C
Revision A