Attaching Hitch To Carrier - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)

4.2 Attaching Hitch to Carrier

1. Remove cam assembly (A) from shipping support (B)
by loosening nuts (C) and sliding the cam assembly off
of the shipping support.
2. Rest the cam assembly on the carrier hydraulics.
3. Remove and discard bolts (B) and shipping support (A).
NOTE:
You may need to pry up the shipping support to remove
the hardware.
4. Remove six M20 bolts (A), washers, and nuts from
carrier at the hitch attachment location. Retain bolts,
washers, and nuts.
214713
A
Figure 4.10: Alignment Controls (Front
Right View)
Figure 4.11: Shipping Support (Front
Right View)
Figure 4.12: Carrier Frame
61
C
B
A
A
B
Revision A