MacDon R116 Unloading And Assembly Instructions page 114

IMPORTANT:
For disc mowers without the Road Friendly Transport
system, proceed to Step
7. Remove nut, bolt, and washer (A) securing the spring
assembly (B) onto the center shield. Retain nut, bolt,
and washer for attaching to transport.
8. Lift center shield and attach spring assembly (A) to link
bracket (B) on transport with existing bolt, nut, and
washer (C) removed in Step
IMPORTANT:
Do NOT bolt center shield to the left and right shields. If
the hardware to attach the center shield to side shields
is installed, remove it and discard.
IMPORTANT:
Only perform this step if NOT installing the Road
™
Friendly Transport
9. Lift center shield (A) and install six M10 x 20 carriage
bolts and lock nuts (B) (three per side) to secure center
shield (A) to the outboard shields (C). Tighten bolts.
214713
SETTING UP THE TRACTOR
9, page 106.
7, page 106.
system.
™
Figure 5.29: Spring on Center Shield
Figure 5.30: Spring Attached to Transport
B
C
Figure 5.31: Center Cover Assembly
106
A
B
B
A
A
B
C
Revision A
C