MacDon R116 Unloading And Assembly Instructions page 59

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
7. Install light assembly (A) onto header left end with two
M10 x 20 carriage bolts (B) and lock nuts from the
shipping bag. Ensure the amber lamp faces the front of
header and reflector faces outboard.
Installing Left Side Transport Harness
1. Retrieve transport harness (A) (MD #281614) from the
shipping bag.
2. Route connectors P201 and P202 on the end of
harness (A) to cover support (D).
3. Using a draw tape or equivalent, route connectors P401
and P404 on the other end of the harness (A) through
opening (B) at front of carrier to opening (C) adjacent to
center-link.
4. Route the harness until the plugs reach the left light
assembly on the header.
5. Locate plug P301 (D) on harness (E) (MD #281613). It
was disconnected from the old lighting module.
6. Connect plug P201 (B) on harness (A) (MD #281614)
into the lower output receptacle on the lighting module.
7. Connect plug P301 (D) to receptacle P202 (C).
214713
Figure 3.102: Header Left Side Lighting
B
Figure 3.103: Harness Routing
E
Figure 3.104: Harness Connection
51
A
B
D
A
C
D
B
C
A
Revision A