MacDon R116 Unloading And Assembly Instructions page 47

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
6. Connect clevis end (B) of the transport swing
cylinder (A) to transport casting. Align holes and install
clevis pin (C). Secure with cotter pin (D).
Installing Transport Wheels
1. Cut the straps securing the transport assembly to the
pallet.
2. Slowly lower forklift until transport assembly wheel
spindles (A) are approximately 305 mm (12 in.) off
the ground.
3. Remove wheel bolts (B) from spindle hub (A) on the
left side.
4. Remove bolt (B) holding axle assembly (A) in place.
5. Slide axle assembly (A) out of the support.
214713
Figure 3.74: Swing Cylinder (Rear Left View)
B
Figure 3.75: Transport Wheel
A
Figure 3.76: Axle Assembly Relocation
39
C
B
A
A
B
Revision A
D