Installing Electrical Components - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)

Installing Electrical Components

Installing Light Assemblies
1. Disconnect the wiring harnesses at the left light
assembly; there are two connectors per assembly.
2. Remove the left light assembly (A).
NOTE:
Right side was removed earlier.
3. Remove red lamp (C) from the right light assembly
(removed in an earlier procedure). Align red lamp (C)
with the predrilled holes, in the left lamp bracket, next to
amber lamp. Secure the red lamp with
existing hardware, as shown.
4. Install right light assembly (A) on the left float spring
mount using bolts (B) removed in Step
lamp (C) should be towards rear of machine when in
transport mode.
5. Retrieve new light bracket (C) from shipment.
6. Install amber lamp (A) and red lamp (B) onto new
bracket (C), previously removed from the right lamp
bracket, with hardware provided.
214713
Figure 3.99: Transport Lighting
2, page 50. Red
Figure 3.100: Left Side of Carrier
Figure 3.101: Light Assembly
50
A
C
B
A
C
A
B
Revision A