Connecting Hydraulics - MacDon R116 Unloading And Assembly Instructions

5.3.3 Connecting Hydraulics

WARNING
Do NOT use remote hydraulic system pressures over 20,684 kPa (3000 psi). Check your tractor operator's
manual for remote system pressure.
NOTE:
Refer to numbered/colored bands on hoses to identify lift, swing/transport, and tilt hose sets.
Table 5.3 Hydraulic System Hoses
System Hose Identification
Red #1 - pressure
Blue #1 - return (only
Lift (A)
with Road Friendly
Transport
Swing/ Red #2 - pressure
Transport (B) Blue #2 - return
Red #3 - pressure
Tilt (C) 2
Blue #3 - return
1. Connect the lift cylinder hose (red collar with #1) to the
tractor's hydraulic receptacle. The second hose
(blue collar with #1) is required only when the Road
™
Friendly Transport
page 98 to confirm system is functioning correctly.
2. Connect the two hitch swing cylinder hoses
(collars with #2) to the tractor hydraulic receptacles.
Refer to Table 5.5, page 98
functioning correctly.
3. For machines with hydraulic center-link only, connect
the two disc mower tilt cylinder hoses (collars with #3)
to the tractor hydraulic receptacles. Refer to Table
page 98 to confirm system is functioning correctly.
2. Available with hydraulic tilt option installed.
214713
SETTING UP THE TRACTOR
Hydraulics
Control 1
™
installed)
Control 2
Control 3
is installed. Refer to Table
to confirm system is
Tractor
Figure 5.15: Hydraulic Connections
Table 5.4 Lift System
Control Lever
Position
5.4,
Forward
Backward
Table 5.5 Hitch Swing and Transport System
Control Lever
Position
Forward
Backward
Table 5.6 Disc Mower Tilt System
Control Lever
5.6,
Position
Forward
Backward
98
Cylinder Disc Mower
Movement Movement
Retract Lower
Extend Raise
Cylinder Disc Mower
Movement Direction
Extend Right
Retract Left
Cylinder Disc Mower
Movement Movement
Retract Lower
Extend Raise
Revision A
A
B
C