MacDon R116 Unloading And Assembly Instructions page 113

4. Support shield (C), remove the two bolts at locations (A)
and (B), and remove the shield.
5. Remove nuts (A) from center shield (B). Do not remove
the bolts.
6. Flip right forming shield over so the adjustment handle
is facing up and install it as follows:
NOTE:
If installing the Road Friendly Transport
shield (A) after transport assembly is in place.
a. Position shield (A) onto hex head bolt (B). Loosely
install nut to hold shield in place.
b. Install carriage bolts (C) with heads facing towards
center of shield. Install nuts and tighten.
c. Repeat for the left side forming shield.
214713
SETTING UP THE TRACTOR
Figure 5.26: Outboard Top Cover
Figure 5.27: Center Shield
™
system, install
Figure 5.28: Forming Shield (Right Side)
105
B
C
A
B
A
A
B
C
A
Revision A