Chapter 6: Lubricating The Disc Mower; Opening Driveshields - MacDon R116 Unloading And Assembly Instructions

Chapter 6: Lubricating the Disc Mower

WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
The disc mower has been lubricated at the factory. However, you should lubricate the disc mower prior to delivery
to offset the effects of weather during outside storage and transport, and to familiarize yourself with the machine.
Unless otherwise specified, use high-temperature, extreme-pressure (EP2) performance grease with 1% max
molybdenum disulphide (NLGI grade 2) lithium base.

6.1 Opening Driveshields

CAUTION
Do NOT operate the machine without the driveshields in place and secured.
NOTE:
Images shown in this procedure are for left driveshield—
right driveshield is similar.
1. Remove lynch pin (A) and tool (B) from pin (C).
214713
Figure 6.1: Left Driveshield
A
C
Figure 6.2: Left Driveshield
119
B
Revision A