4. Position shield (A) so that pins (B) engage the slots in
cutterbar support (C) and the bolt holes align with
panel (D).
5. Install four M16 hex head bolts (A), nuts, and flat
washers to secure shield (B) to the panel (C). Ensure
bolt heads face inboard.
6. Open lift cylinder lock-out valves (A) on both sides of
the mower. Valve handles should be in the open
position (inline with the hose).
214713
SETTING UP THE TRACTOR
Figure 5.53: Left Side of Header (Right
Opposite)
Figure 5.54: Left Side of Header (Right
Opposite)
Figure 5.55: Lift Cylinder Lock-Out Valves
115
A
B
D
C
A
A
B
C
Revision A
A