MacDon R116 Unloading And Assembly Instructions page 232

ü ü Item
Check that cutterbar doors are unbolted from center
channel frame, shipping wire is removed from
cutterbar curtains, and cutterbar curtains are
hanging properly.
Grease all bearings and drivelines.
Check conditioner roll timing gearbox lubricant.
Check disc mower roll timing gearbox lubricant.
Check forward and rear swivel gearbox lubricant.
Check cutterbar lubricant.
Check clutch operation.
Check cutterbar area carefully for loose parts and
hardware on the cutterbar.
WARNING
These objects can be ejected with considerable
force when the machine is started, and may result
in serious injury or machine damage.
Run-Up Procedure
Check hydraulic hose and wiring harness routing to
ensure adequate clearance when raising, lowering or
swinging the header.
Check that tail lights and hazard lights are functional.
Post Run-Up Check – Stop Engine
Check belt drive for proper idler alignment and
overheating bearings.
Check for hydraulic leaks.
Check that header manuals are in storage
compartment.
Date Checked:
214713
REFERENCE
Reference
5.7 Unpacking Curtains, page 110
6.2 Lubrication Points, page 121
7.7 Checking and Adding Conditioner Roll Timing
Gearbox Lubricant, page 134
7.8 Checking and Adding Disc Mower Drive
Gearbox Lubricant, page 135
7.9 Checking and Lubricating Forward and Rear
Swivel Gearboxes, page 136
7.17 Checking Clutch Operation, page 147
7.18 Running up the Header, page 151
7.15 Checking Lights, page 145
7.3 Checking Conditioner Drive Belt, page 129
7.16 Checking Manuals, page 146
Checked by:
224
—
—
—
Revision A