Chapter 5: Setting Up The Tractor; Adjusting The Drawbar - MacDon R116 Unloading And Assembly Instructions

Chapter 5: Setting up the Tractor

This section describes the tractor and drawbar adjustment requirements.

5.1 Adjusting the Drawbar

CAUTION
Shut off tractor, engage parking brake, and remove key before working around hitch.
1. Adjust tractor drawbar to meet the specifications
listed in Table 5.1, page
2. Secure the tractor drawbar so the hitch pinhole is
directly below the driveline.
Table 5.1 SAE Standard A482 Specifications
Dimension
X
Y
Z
214713
91.
1-3/8 in. Diameter
406 mm (16 in.)
Figure 5.1: Tractor Drawbar Adjustments
A - PTO
C - Ground
Y - Dimension Y
1000 rpm Power Take-Off
200–350 mm (7-7/8–13-3/4 in.)
203 mm (8 in.) recommended
330–432 mm (13–17 in.)
406 mm (16 in.) recommended
91
X
Y
Z
B - Tractor Drawbar
X - Dimension X
Z - Dimension Z
1-3/4 in. Diameter
508 mm (20 in.)
Revision A
A
B
C