MacDon R116 Unloading And Assembly Instructions page 79

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
16. Remove cone shield (A).
17. Retrieve the primary driveline (D) from the shipping
location.
18. Remove nut (C), washer (B), and pin (A) from the disc
mower end of primary driveline (D).
19. Slide driveline (A) onto gearbox input shaft (B). Align
the pinhole in the yoke with the groove on the
input shaft.
214713
A
Figure 4.38: Cone Shield
Figure 4.39: Primary Driveline
A
Figure 4.40: Primary Driveline
71
D
A
B
C
B
Revision A