Discharge Shield (No Conditioner); Removing Discharge Shield (No Conditioner) - MacDon R116 Unloading And Assembly Instructions

5.8 Discharge Shield (No Conditioner)

•
If a conditioner is being installed, the discharge shield needs to be removed. Refer to
Shield (No Conditioner), page
•
If a conditioner is being removed, the discharge shield needs to be installed. Refer to
Shield (No Conditioner), page

5.8.1 Removing Discharge Shield (No Conditioner)

Follow these steps to remove the shielding installed on a mower configured without a conditioner:
1. Raise the mower fully and extend the center-link to
maximize the space between shield (A) and carrier
frame (B).
2. Close lift cylinder lock-out valves (A) on both sides of
the mower. Valve handles should be in the closed
position (90 degree angle to the hose).
214713
SETTING UP THE TRACTOR
112.
114.
112
Figure 5.45: Mower with Transport
Figure 5.46: Lift Cylinder Lock-Out Valves
5.8.1 Removing Discharge
5.8.2 Installing Discharge
B
A
A
Revision A