Installing Hydraulic Lines And Hoses - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
4. Ensure the end of cam arm (A) is parallel with the clevis
end (B) of the cylinder. If adjustment is required, use a
bar and turn the clevis until the clevis is parallel with
cam arm (A).
NOTE:
The clevis end of cylinder will be attached to Road
™
Friendly Transport
primed. Refer to 5.5 Priming the Hitch Swing Cylinder,
page 102.

4.8.3 Installing Hydraulic Lines and Hoses

This procedure explains how to install the transport hydraulic control system.
NOTE:
For hydraulic fitting installation details, refer to
1. Place a container or rag under the fitting on the hitch
swing cylinder.
2. Remove the existing fitting at location (A) from
the block.
3. Remove cap from fitting (C).
IMPORTANT:
Ensure O-ring is in place.
4. Retrieve ORFS-6 x ORB-6 connector (B) from shipping
bag A and install into location (A).
214713
system casting when the system is
11.6 Torque Specifications, page
Figure 4.60: Cam Arm Alignment
208.
Figure 4.61: Alignment Valve Fitting
81
A
B
C
B
A
Revision A