MacDon R116 Unloading And Assembly Instructions page 70

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
5. Cut banding (A) securing wood supports, then
remove supports (B).
6. Remove the two bolts (C) securing wood support to
hitch pin. Discard bolts.
7. Place sling (A) around the hitch frame. Adjust sling
position until hitch is balanced when lifting.
•
R113: Approximately 270 cm (106 in.) from the edge
of the tractor end of the hitch (B)
•
R116: Approximately 350 cm (138 in.) from the edge
of the tractor end of the hitch (B)
8. Raise the hitch approximately 610 mm (24 in.) off
the ground.
NOTE:
Pin (C) is heavy; support it appropriately before
removing bolt (A).
9. Support pin (C), remove bolt (A) and wood block (B)
from top of pin, and then remove pin (C).
214713
C
B
Figure 4.13: Hitch Packing
A
Figure 4.14: Lifting Hitch
A
B
C
Figure 4.15: Hitch Packing
62
A
B
Revision A