MacDon R116 Unloading And Assembly Instructions page 49

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
3. Secure cam assembly (A) onto hitch swing cylinder
plate (B) with bolts and nuts (C). Torque nuts (C) to
55–60 Nm (40–45 lbf·ft).
NOTE:
When installing cam assembly (A), check for hose
twisting. If required, loosen hose fitting to allow hose to
untwist. Torque fitting when complete.
4. Remove two bolts (B), then remove shipping
support (A) and discard.
5. Check the travel of cam arm (A) by sliding it in and out
of cam assembly (B).
NOTE:
If the cam arm does not slide easily, loosen valve
mounting bolts (C) and position valve (B) at the top of
the mounting holes. Retighten valve mounting bolts (C).
214713
B
C
Figure 3.80: Alignment Control (Rear
Right View)
Figure 3.81: Shipping Support (Front
Right View)
Figure 3.82: Alignment Control (Rear
Right View)
41
B
A
B
A
C
A
Revision A