Adjusting Clutch - MacDon R116 Unloading And Assembly Instructions

11. If acceptable slippage is detected, retighten clutch
spring adjustment nuts (B). Refer to
Clutch, page 148.
12. If acceptable slippage is not detected, the clutch should
be removed and disassembled for inspection/repair.
Contact your MacDon Dealer.
13. Slide the shield cone to the gearbox and secure with the
two lever clamps (A).

7.17.1 Adjusting Clutch

1. Release two lever clamps (A) on the shield cone
installed at the header swivel gearbox.
214713
PERFORMING PREDELIVERY CHECKS
7.17.1 Adjusting
148
Figure 7.34: Driveline Shield Cone
Figure 7.35: Driveline Shield Cone
A
A
Revision A