ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
6. Slide cone (A) onto driveline with latches (B) towards
the gearbox.
7. Remove nut (C) and washer (E) from tapered pin (D),
and tap out pin from yoke using a hammer.
8. Attach driveline (A) to the upper rear swivel
gearbox shaft.
9. Insert tapered pin (A) by hand. Ensure the pin lines up
with groove in the yoke and is fully inserted. The notch
in the pin should be facing toward the shaft.
10. Clean the threads on pin (A) after it has been inserted.
11. Install washer (B) and nut (C) on the tapered pin, and
then torque to 149 Nm (110 lbf·ft). The end of the pin
must be recessed 0–2 mm (0–0.08 in.) (D).
NOTE:
Do NOT use an impact wrench to install or torque
the nut.
12. Install the shield onto the upper rear swivel gearbox.
Use the latches to secure it.
214713
C
E
Figure 4.48: Clutch Driveline
Figure 4.49: Clutch Driveline
B
C
Figure 4.50: Clutch Driveline
75
A
D
A
A
D
B
Revision A