MacDon R116 Unloading And Assembly Instructions page 162

1. Connect the disc mower hitch to the tractor. Refer to the
disc mower operator's manual.
2. Turn the handle on jack stand (A) to raise the stand.
3. Remove pin (B) and stand (A).
4. Move jack (A) to storage position on side of hitch, align
the mounting holes and secure with pin (B).
NOTE:
If unit is equipped with a two-point hitch, rotate the hitch
stand to the storage position.
5. Raise the disc mower fully and close the lift cylinder
lock-out valve by turning handle (A) to the closed
position (90 degree angle to the hose). Repeat on
opposite side.
214713
TRANSPORTING THE DISC MOWER
154
B
Figure 8.1: Jack in Storage Position
B
A
Figure 8.2: Jack in Storage Position
Figure 8.3: Cylinder Lock-Out Valve
A
A
Revision A