Completing Road Friendly Transport ™ System Installation; Removing Cover; Installing Transport Alignment Control - MacDon R116 Unloading And Assembly Instructions

ASSEMBLING THE DISC MOWER (FACTORY-INSTALLED TRANSPORT)
4.8 Completing Road Friendly Transport
This section describes the installation of the base components, the hydraulic lines and hoses, and the electrical
connections for the Road Friendly Transport

4.8.1 Removing Cover

1. Remove bolts (B) from cover (A).
2. Remove cover (A).

4.8.2 Installing Transport Alignment Control

This section describes the installation of the base components of the Road Friendly Transport
1. Secure the cam assembly (A) onto the hitch swing
cylinder plate (B) with bolts and nuts (C). Torque
nuts (C) to 55–60 Nm (40–45 lbf·ft).
NOTE:
When installing the cam assembly (A), check for hose
twisting. If required, loosen hose fitting to allow hose to
untwist. Torque fitting once complete.
214713
™
system.
Figure 4.56: Cover (Top View)
Figure 4.57: Alignment Control (Rear
Right View)
79
™ ™
System Installation
A
B
™
B
C
system.
A
Revision A