MacDon R116 Unloading And Assembly Instructions page 54

ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)
13. Install hose (A) from outer port (rod end) on transport
cylinder block to tee fitting (D) in port D of transport
swing control.
14. Install hose (B) from inner port (base end) on transport
cylinder block to tee fitting (C) in port C of transport
swing control.
15. Connect hose (B) with red collar #2, from the rear of the
hitch, to fitting in port A1 on selector valve (C).
16. Connect hose (A) with blue collar #2, from the rear of
the hitch, to fitting in port A2 of the selector valve (C).
17. Secure hoses (A) and (B) together with cable tie.
214713
Figure 3.91: Transport Swing Control
A
Figure 3.92: Selector Valve Supply
46
A
B
D
C
B
Revision A
C