MacDon R116 Unloading And Assembly Instructions page 104

6. Check distance (C) between tractor primary
power take-off (PTO) shaft (A) and disc mower hitch
gearbox shaft (B) (without the front half of the driveline
attached).
7. Ensure that distance measurement (C) does NOT
exceed the dimensions listed in Table
Table 5.2 Distance between Hitch Gearbox and
Tractor PTO
Driveline Shaft Size
34 mm (1-3/8 in.)
43 mm (1-3/4 in.)
8. Position primary driveline (A) onto tractor PTO shaft,
making sure that driveline is approximately level.
9. Pull back collar on driveline (A) and push driveline until
it locks. Release collar.
10. Clear bystanders from the area and start tractor. Do
NOT operate the disc mower.
11. Start tractor and raise hitch so that stand (A) is off the
ground. Shut down tractor and remove key
from ignition.
12. Remove inner hairpin (B) and pull lock (C) to
release stand.
1. If distance (C) is greater than the values shown, a longer driveline is required. Refer to the disc mower
operator's manual, options and attachments section for ordering information.
214713
SETTING UP THE TRACTOR
5.2, page 96.
Distance (C) 1
650 mm (25-9/16 in.)
750 mm (29-1/2 in.)
96
C
A
B
Figure 5.10: Allowable Driveline Length
Figure 5.11: Disc Mower Driveline Attached to
Tractor PTO
B
Figure 5.12: Hitch Stand
A
C
A
Revision A