Installing Electrical Components - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT

Installing Electrical Components

Wiring harnesses, lighting assemblies, the selector valve and lighting module, and the remote control are components on
the electrical system.
Installing Light Assemblies
Light assemblies provide position, hazard, turning direction, and braking information.
1. Disconnect the wiring harnesses at the left light assembly;
there are two connectors per assembly.
2. Remove left light assembly (A).
NOTE:
The right light assembly was removed earlier.
3. Remove lamps (B). Retain lamps and hardware for
installation.
4. Remove red lamp (C) from the right light assembly
(removed in an earlier procedure). Align red lamp (C) with
the predrilled holes in the right lamp bracket, next to
amber lamp. Secure the red lamp with existing hardware,
as shown.
5. Install right light assembly (A) on the left float spring mount
using two nuts (B) and two bolts from the shipping bag.
NOTE:
Red lamp (C) should be towards rear of machine when in
transport mode.
6. Retrieve new light bracket (C) from shipment.
7. Install amber lamp (A) and red lamp (B) onto new
bracket (C), previously removed from the left lamp bracket,
with hardware provided.
215585
Figure 3.103: Transport Lighting
Figure 3.104: Left Side of Carrier
Figure 3.105: Light Assembly
51
Revision A