Installing Electrical Components - MacDon R113 Installation Instructions Manual

3.3 Installing Electrical Components

1. If M205 is equipped with a draper/auger header drive,
disconnect hose bundle connectors (not shown) from
chassis harness connectors labeled HC-2 (A) and HC-1 (B).
NOTE:
If M205 was connected to an R80/R85 rotary disc header,
the header was disconnected from the chassis harness
when the header was detached from the windrower.
2. Connect adapter harness (MD #256650) as follows:
• Connect 8-pin female connector (C) to chassis harness
connector HC-2 (A).
• Route harness between frame channel and
protrusion (D) (shown partly cutoff), and on top of the
front axle.
• Connect 2-pin male connector (E) to R113 header
connector (F).
Installing Header Drive Pump Power Width Modulation (PWM) Module
3. Disconnect 4-pin female piston pump connector (A) from
header pump relay harness (B).
215276
INSTALLATION INSTRUCTIONS
Figure 3.21: Adapter Harness (MD #256650)
Installation
Figure 3.22: Piston Pump
16
F E
C
D
B
B
A
A
Revision A