Installing Header Electrical Harness - MacDon Draper D65 Installation Instructions Manual

3.2 Installing Header Electrical Harness

To install the header electrical harness, follow these steps:
1. At the inside top of the left header leg, remove cap on
connector (A) and cut cable tie (B).
2. Route connector (A) and wiring harness (B) under the leg to
the axle and through bracket (C).
3. Orient clip (B) with notch (D) at top and insert
connector (A). Attach clip assembly to bracket (C) with two
1/4 x 1/2 in. self-tapping screws (E) and tighten.
169784
INSTALLATION INSTRUCTIONS
Figure 3.10: Left Header Leg
Figure 3.11: Front Axle
B
Figure 3.12: Front Axle
19
A
B
C
A
E
D
C
A
B
Revision H