Flooded Engine; Bank Angle Sensor Ignition Cut-Off System - Honda FOURTRAX RUBICON 2018 Owner's Manual

Table of Contents

Advertisement

Starting & Stopping the Engine

Flooded Engine

If the engine fails to start after repeated attempts, it may be flooded
with excess fuel. To clear a flooded engine:
1. Leave the engine stop switch set to RUN (e).
2. Open the throttle fully.
3. Press the start/over ride button for 5 seconds (or operate the
recoil starter several times).
4. Follow the normal starting procedure.
5. If the engine starts, then open the throttle slightly if idling is
unstable.
If the engine does not start, wait 10 seconds, then follow steps
1 – 4 again.
If the engine still won't start, refer to If Your Engine Quits or Won't
Start, page 218.

Bank Angle Sensor Ignition Cut-off System

Your vehicle's banking (lean angle) sensor system is designed to
automatically stop the engine if the vehicle is overturned.
Before restarting the engine, you must turn the ignition switch to the
OFF (w) position and then back to ON (q). The engine will not restart
until you perform this procedure.
Basic Operation & Riding
85

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fourtrax rubicon 2019Trx500fa6Trx500fa7Trx500fa6-fa7

Table of Contents