Table of Contents
Advertisement
Configuration with TIA Portal
TIA Portal - Hardware configuration - Ethernet PG/OP channel
Setting VIPA specific CPU
parameters
10.3
TIA Portal - Hardware configuration - Ethernet PG/OP channel
Overview
Assembly and commis-
sioning
222
5.
Select in the Network view the IO device 'VIPA SLIO CPU...' and switch to the
Device overview.
ð In the Device overview of the PROFINET IO device 'VIPA SLIO CPU' the CPU
is already placed at slot 0. From slot 1 you can place your System SLIO
modules.
For parametrization click at the CPU at slot 0 in the Device overview of the PROFINET IO
device 'VIPA SLIO CPU' . Then the parameters of the CPU part are shown in the Proper-
ties dialog. Here you can make your parameter settings.
specific CPU parameters' on page 70
The CPU has an integrated Ethernet PG/OP channel. This channel allows you to pro-
gram and remote control your CPU.
n
The Ethernet PG/OP channel (X1/X2) is designed as switch. This enables PG/OP
communication via the connections X1 and X2.
n
The Ethernet PG/OP channel also gives you access to the internal web page that
contains information about firmware version, connected I/O devices, current cycle
times etc.
n
At the first commissioning respectively after a factory reset the Ethernet PG/OP
channel has no IP address.
n
For online access to the CPU via the Ethernet PG/OP channel, valid IP address
parameters have to be assigned to this. This is called "initialization".
n
This can be done with the Siemens TIA Portal.
1.
Install your System SLIO with your CPU.
2.
Wire the system by connecting cables for voltage supply and signals.
3.
Connect the one of the Ethernet jacks (X1, X2) of the Ethernet PG/OP channel to
Ethernet.
VIPA System SLIO
Ä Chapter 4.8 'Setting VIPA
HB300 | CPU | 013-CCF0R00 | en | 16-40
Advertisement
Table of Contents
