Ripng Configuration Examples; Configuring Ripng Basic Functions - HPE FlexNetwork HSR6800 Configuration Manual

RIPng configuration examples

Configuring RIPng basic functions

Network requirements
As shown in
to filter the route (3::/64) learned from Router C, which means the route is not added to the routing
table of Router B, and Router B does not forward it to Router A.
Figure 93 Network diagram
Configuration procedure
Configure the IPv6 address for each interface. (Details not shown.)
1.
Configure basic RIPng functions:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-Gigabitethernet2/1/1] ripng 1 enable
[RouterA-Gigabitethernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-Gigabitethernet2/1/2] ripng 1 enable
[RouterA-Gigabitethernet2/1/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-Gigabitethernet2/1/1] ripng 1 enable
[RouterB-Gigabitethernet2/1/1] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-Gigabitethernet2/1/2] ripng 1 enable
[RouterB-Gigabitethernet2/1/2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] ripng 1
[RouterC-ripng-1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-Gigabitethernet2/1/1] ripng 1 enable
[RouterC-Gigabitethernet2/1/1] quit
[RouterC] interface gigabitethernet 2/1/2
Figure 93, all routers learn IPv6 routing information through RIPng. Configure Router B
295